How to Access Actelis ML62x - Using Management Interface in MetaAssist View

I have been using this modem for a while now, and i want to share a useful tip on how to access your modem using management interface.  Let's say, you forgot your usb-to-serial interface cable or  a serial cable (db9 connector)  and cannot access the modem locally using your laptop to check an alarm.

Ok here's the simple tip.

+   Before you deploy your modem to remote sites, make sure that
     COLAN interface port is set to Enable.

+  Open the Management Interface Menu, and set an Ip Address to
     IP Interface.

   e.g.

        *  IP Address:  10.10.10.10

        *  Subnet Mask: 255.255.255.0

        *  Gateway: 10.10.10.1

+  Close and Open the MetaAssist View, then use a cross-over cable
     and plug it into MGMT port of the modem.