ADTRAN 6540 Express Setup Guide

We will be using a Hyperterminal to setup the modem.

Modem Setup;

Com Ports : N

Port Setting, you may click default button to simplify setup;

9600 bits per second

8 for Data Bits

None for Parity

1 for Stop Bits

None for Flow Control

Using the modem as 2W in Point-to-Point Setup.

Power-Up the modem

Connect the cable (RJ45) using pin 1 & 2 as Tip and Ring of a line between Modem A and Modem B

LTU Side

First, we have to identify which is the LTU and the NTU modem

In an above sample, we will be using the Modem A as an LTU,

Goto MainMenu then select the Unit Information, if the modem is in default setup which is in NTU Mode.

Goto MainMenu> Provisioning> Unit Option

Unit mode

Under Unit mode select, LTU

Set the modem to use a 2W line

Goto MainMenu> Provisioning

Interface Mode

Select the 2W

Set the modem Payload Rate, we will be using a 512kbps as a sample rate

Goto MainMenu> Provisionong

Payload Rate

In Payload Rate Page, we used the Nx64 formula or 512 / 64 = N, N=8

After setting the Payload Rate, we will goto Cross-Connection Map to activate the payload

Goto MainMenu> Provisioning> Unit Option> Cross-Connect Map

Under Cross-Connect map, you have notice that there are 8 active payload,

Activate every payload by entering 33 or simply type N to activate all.

Then save.

NTU Side

Set the modem as NTU, do the procedure like we set the LTU

Wait for 1 minute while the two modem synchronize

When Modem HDSL Sync, Modem A (LTU) will update the Modem B (NTU)

Goto Cross-Connect Map to activate the Payload.

Then Save.

You may leave comment to request for your own sample setup

>> More sample Setup to come <<

___________________________________________________

Share this you friend....

Data Ops - O&M