How to Configure Ericsson ECN320/330

Here is the basic steps in configuring a New ECN320/330

Accessing the ECN320/330

1. Open the Hyperteminal of your Laptop/Desktop, configure it in default Com Port Settings (9600, 8, N, 1, N).
2. Connect to ECN using the proprietary cable (included in the box), in Hyperterminal Press Enter (you should see the ECN32x#)
3. If cable is not included, connect it using LAN Cable (straight) and insert in any of the 24 ports then configure your Laptop/Desktop to Obtain IP automatically.
4. Run the command prompt and check what IP was obtain.
5. Open your browser and enter the Obtained Default Gateway in the address bar.
6. You should see the Username/Password

Configuring ECN320/330

On the ecn320# prompt type in the following:
      ecn320# config system interface external vlan 246 ip x.x.x.x netmask y.y.y.y. 
  ecn320# config system interface default-gateway z.z.z.z ecn320# config system pem-management port 26 {optional} 
  ecn320# config system interface activate

TAC ECN VLAN Configuration

Sample:      

  TAC-01# show system interface
    External VLAN: 246 IP: <ip address> Netmask: <netmask> Priority: 7
    Internal VLAN: 247 IP: <ip address> Netmask: <netmask>
    Untagged VLAN: 248 IP: <ip address> Netmask: <netmask>
    Default Gateway: <ip address>

Note: After issuing the interface activate command, the ECN320 unit will reset. To synchronize the time of the equipment with the time of the NMS type in the ff.  

ecn320# config system ntp server-ip <ip address>
ecn320# config save {Saves the configuration done}

You could manually set the time and date on the ECN320 by typing:  

ecn320# config system calendar date 8.08.06 time 09:30:00